微信掃一掃，立即回復！
| 編號 | 中文名稱 | 英文名稱 |
|---|---|---|
| ANSI/AISI/COS TS-6 | 板式和錨式結構試驗標準程序 | Standard Procedures for Panel and Anchor Structural Tests |
| ANSI/API SPEC2F | 系泊錨鏈 | Mooring Chain |
| ANSI/ASTM E754 | 埋入砌筑砂漿縫中的拉桿和錨的拉拔阻力的試驗方法 | Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints (04.11) |
| ANSI/ASTM E894 | 建筑物護欄和永久金屬護欄系統用錨固裝置的試驗方法 | Test Method for Anchorage of Permanent Metal Railing Systems and Rails for Buildings (04.11) |
| ANSI/ASTM F765 | 錨鏈輪規范.船錨鏈 | Specification for Wildcats, Ship Anchor Chain |
| ANSI/ASTM F936 | 巴拿馬錨用鑄鋼輪擋規范 | Specification for Chocks, Panama, Mooring Cast Steel |
| ANSI/ASTM F937 | 船錨用鑄鋼輪擋規范 | Specification for Chocks, Ship Mooring, Cast Steel |
| ANSI/SAE J1369 | 后座兒童減震系繩搭板錨固規定 | Anchorage Provisions for Installation of Child Restraint Tether Straps in Rear Seating Positions |
| ASTM A 981 | 評估預應力地下錨定裝置用270級未涂覆15.2mm(0.6in)直徑預應力鋼絞線結合強度的標準試驗方法 | Standard Test Method for Evaluating Bond Strength for 15.2 mm (0.6 in.) Diameter Prestressing Steel Strand, Grade 270, Uncoated, Used in Prestressed Ground Anchors |
| ASTM C 1242 | 規格石錨固系統的選擇、設計和安裝的標準指南 | Standard Guide for Selection, Design, and Installation of Dimension Stone Anchoring Systems |
| ASTM D 4435 | 石栓錨定拉力試驗的標準試驗方法 | Standard Test Method for Rock Bolt Anchor Pull Test |
| ASTM E 1512 | 測試粘接的錨的粘結性能的標準試驗方法 | Standard Test Methods for Testing Bond Performance of Bonded Anchors |
| ASTM E 2265 | 混凝土和磚石工程用錨和緊固件的標準術語 | Standard Terminology for Anchors and Fasteners in Concrete and Masonry |
| ASTM E 488 | 混凝土及砌塊構件中錨定強度的試驗方法 | Standard Test Methods for Strength of Anchors in Concrete and Masonry Elements |
| ASTM E 754 | 埋入磚石灰縫中的拉桿和錨的拔拉阻力的標準測試方法 | Standard Test Method for Pullout Resistance of Ties and Anchors Embedded in Masonry Mortar Joints |
| ASTM E 894 | 建筑物用永久性金屬圍欄系統及圍欄的錨定試驗 | Standard Test Method for Anchorage of Permanent Metal Railing Systems and Rails for Buildings |
| ASTM F 1554 | 屈服應力為36、55和105ksi的鋼制錨固螺栓用標準規范 | Standard Specification for Anchor Bolts, Steel, 36, 55, and 105-ksi Yield Strength |
| ASTM F 2437 | 與螺旋帽、螺栓、錨和螺柱用碳和合金鋼可壓縮墊圈式直讀張力指示器的標準規范 | Standard Specification for Carbon and Alloy Steel Compressible-Washer-Type Direct Tension Indicators for Use with Cap Screws, Bolts, Anchors, and Studs |
| ASTM F 765 | 船用錨鏈及錨鏈輪 | Standard Specification for Wildcats, Ship Anchor Chain |
| ASTM F 936 | 巴拿馬鑄鋼船錨塞塊 | Chocks, Panama, Mooring Cast Steel |
| ASTM F 937 | 鑄鋼船錨塞塊 | Chocks, Ship Mooring, Cast Steel |
| 編號 | 中文名稱 | 英文名稱 |