微信掃一掃，立即回復！
| 編號 | 中文名稱 | 英文名稱 |
|---|---|---|
| BS 2S 513 | 彈簧鋼帶材規范 | Specification for spring steel strip |
| BS 3S 500 | 鋼板和鋼帶檢驗、試驗及驗收程序 | Procedure for inspection, testing and acceptance of steel sheet and strip |
| BS 5S 100 | 鍛鋼制品(鋼板、薄鋼板、鋼帶和鋼管除外)檢驗、試驗和驗收程序 | Procedure for inspection, testing and acceptance of wrought steels (other than plate, sheet, strip and tube) |
| BS 7870-8.4 | 配電和發電設施用低壓(LV)和中等電壓(MV)聚合絕緣電纜.地上和地下安裝用多芯和多對電纜規范.具有降低火焰?zhèn)? | LV and MV polymeric insulated cables for use by distribution and generation utilities - Specification for multicore and multipair cables for installation above and below ground - Single wire or double steel tape armoured and PVC sheathed multipair cable with copper conductors, having reduced fire propagation performance - Section 8.4 Single wire or double steel tape armoured and PVC sheathed multipair cable with copper conductors, having reduced fire propagation performance |
| BS 7870-8.6 | 配電和發電設施用低壓(LV)和中等電壓(MV)聚合絕緣電纜.地上和地下安裝用多芯和多對電纜規范.單絲或雙鋼帶鎧 | LV and MV polymeric insulated cables for use by distribution and generation utilities - Specification for multicore and multipair cables for installation above and below ground - Single wire or double steel tape armoured and non-halogenated sheathed multipair cable with copper conductors - Section 8.6 Single wire or double steel tape armoured and non-halogenated sheathed multipair cable with copper conductors |
| BS EN 10048 | 熱軋窄鋼帶.尺寸和形狀公差 | Hot rolled narrow steel strip - Tolerances on dimensions and shape |
| BS EN 10106 | 經完全處理后交付的冷軋非定向電工鋼片和鋼帶 | Cold rolled non-oriented electrical steel sheet and strip delivered in the fully processed state |
| BS EN 10107 | 加工完畢出廠的顆粒取向的電工鋼片和鋼帶 | Grain-oriented electrical steel sheet and strip delivered in the fully processed state |
| BS EN 10140 | 冷軋窄鋼帶.尺寸和形狀公差 | Cold rolled narrow steel strip - Tolerances on dimensions and shape |
| BS EN 10143 | 連續熱浸涂覆的薄鋼板和鋼帶.尺寸和形狀公差 | Continuously hot-dip coated steel sheet and strip - Tolerances on dimensions and shape |
| BS EN 10151 | 彈簧用不銹鋼帶材.交貨技術條件 | Stainless steel strip for springs - Technical delivery conditions |
| BS EN 10251 | 磁性材料.電工鋼片和鋼帶幾何特性值測定方法 | Magnetic materials - Methods of determination of the geometrical characteristics of electrical steel sheet and strip |
| BS EN 13246 | 包裝.捆扎鋼帶規范 | Packaging - Specification for tensional steel strapping |
| BS EN 523 | 預應力鋼筋用鋼帶材制鋼筋鞘管.術語、要求和質量控制 | Steel strip sheaths for prestressing tendons - Terminology, requirements, quality control |
| BS EN 524-1 | 預應力鋼絲索用鋼帶護套.試驗方法.形狀及尺寸的測定 | Steel strip sheaths for prestressing tendons - Test methods - Determination of shape and dimensions |
| BS EN 524-2 | 預應力鋼絲索用鋼帶護套.試驗方法.撓性的測定 | Steel strip sheaths for prestressing tendons - Test methods - Determination of flexural behaviour |
| BS EN 524-3 | 預應力鋼絲索用鋼帶護套.試驗方法.反復彎曲試驗 | Steel strip sheaths for prestressing tendons - Test methods - To-and-fro bending test |
| BS EN 524-4 | 預應力鋼絲索用鋼帶護套.試驗方法 . 抗側面負荷力的測定 | Steel strip sheaths for prestressing tendons - Test methods - Determination of lateral load resistance |
| BS EN 524-5 | 預應力鋼絲索用鋼帶護套.試驗方法.抗拉負荷力的測定 | Steel strip sheaths for prestressing tendons - Test methods - Determination of tensile load resistance |
| BS EN 524-6 | 預應力鋼絲索用鋼帶護套.試驗方法.密閉性的測定（水損失的測定） | Steel strip sheaths for prestressing tendons - Test methods - Determination of leaktightness (determination of water loss) |
| BS S 538 | 鉻-鎳-鉬-釩耐熱鋼薄板材和鋼帶規范(930-1130MPa:最大厚度6mm)(鉻12、鎳2.5、鉬1.7、釩0.3) | Specification for chromium-nickel-molybdenum-vanadium heat-resisting steel sheet and strip (930-1130 MPa: maximum thickness 6 mm) (Cr 12, Ni 2.5, Mo 1.7, V 0.3) |
| 編號 | 中文名稱 | 英文名稱 |